Truma 8mm olive

  • Thread starter Thread starter WebMonkey
  • Start date Start date

WebMonkey

Guest
This may be a bit of a long shot but:

Just about to install a Propex heater on my van and want to bring the supply pipe out of the bottom of the existing 3 way Truma manifold prior to running it through a single gas valve located nearer to the heater. Only probelm is Truma valves have their own style brass olives and I'm having difficulty finding a supplier.

I've found one supplier that sells a Truma Gok Stepped olive which looks very similar to the one I need, but its not exactly the same. Just wondered if anyone knows of a supplier of Truma olives or has successfully used a Truma Gok Stepped Olive in a Truma valve.

This is what the stepped olive looks like: Truma Gok Stepped olive 8mm

Cheers
Chris
 
Another place worth a try is Leisure Spares

I needed an obscure part for a Cramer hob lid. Rang them up and they couldn't be more helpful. Sent a photo and the part was sourced for me.

Best of luck!
 
Pretty sure I have some at my workshop I'll be down there tomorrow so I'll check , if you pm me your address I'll send you one....... Mark
 
Last edited:
Thanks

Thanks for the info Guys and for the kind offer Full Timer, much appreciated.
 
You must log in or register to reply here.

Users who viewed this discussion (Total:0)

Back
Top