Dezi
Full Member
- Posts
- 4,008
- Likes
- 5,564
Hi,
Having got the new fiat ducato & going Continental you need fit the fiat headlight protectors (£66 + vat & made in Australia ) before you can affix the beam diverters.
The instructions supplied are **** so use the following:-
1] open bonnet & locate two phillip screws either side.
2] remove triangular piece of plastic bodywork.
3] fit metal clip onto cover and place in slot on protector, cover metal with sticky clear plastic supplied.
4] refit bodywork, semi tighten screws.
fit plastic lugs onto bottom of headlight cover & push under rubber headlight seal.
5] tighten screws - gently close bonnet.
CAUTION - be careful because if you lose any little bit - its a complete new set (£66 + vat & made in Australia ), spares are NOT sold for this pack.
Dezi
Having got the new fiat ducato & going Continental you need fit the fiat headlight protectors (£66 + vat & made in Australia ) before you can affix the beam diverters.
The instructions supplied are **** so use the following:-
1] open bonnet & locate two phillip screws either side.
2] remove triangular piece of plastic bodywork.
3] fit metal clip onto cover and place in slot on protector, cover metal with sticky clear plastic supplied.
4] refit bodywork, semi tighten screws.
fit plastic lugs onto bottom of headlight cover & push under rubber headlight seal.
5] tighten screws - gently close bonnet.
CAUTION - be careful because if you lose any little bit - its a complete new set (£66 + vat & made in Australia ), spares are NOT sold for this pack.
Dezi