Boris7
Full Member
- Posts
- 2,767
- Likes
- 7,049
Had Lithium batteries fitted by RoadPro couple of years back.
Last year S&G fitted an inverter, all good
Then a few months back started getting an issue with the display panel saying batteries were depleted while using the inverter, once the electrical item was turned off the display returned to normal and battery levels were fine.
Yesterday I had to take the van back to S&G for an unrelated item, but asked them to have a look at the electrical issue above, on collecting the Van they explained they had checked it over, ran some tests and identified the display was faulty, they had already spoken to RoadPro and been told if I went in they would change the display.
Popped into RoadPro, they had the panel ready as agreed, but when they tested the old panel it worked with no issues, I was a bit confused as it had been doing this for months, RoadPro did everything to make it fail, boiled kettles, turnd everything on, plugged tools in etc and it just worked 100% perfect.
Left feeling a little stupid.
Now its still working, but the mains socket next to the microwave and adjacent to the panel no longer works.
Any ideas?
Last year S&G fitted an inverter, all good
Then a few months back started getting an issue with the display panel saying batteries were depleted while using the inverter, once the electrical item was turned off the display returned to normal and battery levels were fine.
Yesterday I had to take the van back to S&G for an unrelated item, but asked them to have a look at the electrical issue above, on collecting the Van they explained they had checked it over, ran some tests and identified the display was faulty, they had already spoken to RoadPro and been told if I went in they would change the display.
Popped into RoadPro, they had the panel ready as agreed, but when they tested the old panel it worked with no issues, I was a bit confused as it had been doing this for months, RoadPro did everything to make it fail, boiled kettles, turnd everything on, plugged tools in etc and it just worked 100% perfect.
Left feeling a little stupid.
Now its still working, but the mains socket next to the microwave and adjacent to the panel no longer works.
Any ideas?